R&S RTO6 - 13.13.5.2 ARINC search results

Protocol analysis
R&S
®
RTO6
713User Manual 1801.6687.02 ─ 05
Remote command:
SEARch:
TRIGger:ARINc:
DATA:CONDition on page 1994
SEARch:TRIGger:ARINc:DATA:MIN on page 1994
SEARch:TRIGger:ARINc:DATA:MAX on page 1994
SDI / SSM setup: SDI, SSM
The SDI / SSM setup consists of the SDI and SSM.
The SDI / SSM setup settings are the same as in the ARINC trigger setup, see "SDI /
SSM" on page 709.
Remote command:
SEARch:TRIGger:ARINc:SDI on page 1995
SEARch:TRIGger:ARINc:SSM on page 1995
Error Condition
Selects the error type to be searched for. You can select one or more error types as
search condition.
The error types are the same as in the ARINC trigger setup, see "Error Conditions"
on page 709
Remote command:
SEARch:TRIGger:ARINc:ERRor:CODing on page 1995
SEARch:TRIGger:ARINc:ERRor:PARity on page 1995
SEARch:TRIGger:ARINc:ERRor:TIMing on page 1996
13.13.5.2 ARINC search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 420
●
Chapter 11.4.2, "Display zoom settings", on page 440
Remote commands:
●
SEARch:RESult:ARINc:WCOunt? on page 1998
●
SEARch:RESult:ARINc:WORD<m>:DATA? on page 1997
●
SEARch:RESult:ARINc:WORD<m>:LABel? on page 1996
●
SEARch:RESult:ARINc:WORD<m>:PATTern? on page 1996
●
SEARch:RESult:ARINc:WORD<m>:SDI? on page 1998
●
SEARch:RESult:ARINc:WORD<m>:SSM? on page 1997
●
SEARch:RESult:ARINc:WORD<m>:STARt? on page 1999
●
SEARch:RESult:ARINc:WORD<m>:STATe? on page 1998
●
SEARch:RESult:ARINc:WORD<m>:STOP? on page 1998
ARINC 429 (option R&S R
T
O6-K530)