R&S ZNA26 - Page 1365

Command reference
R&S
®
ZNA
1365User Manual 1178.6462.02 ─ 20
Suffix:
<Ch>
.
Channel number
Parameters:
<GCModesGlobal> LNOise | LDIStortion | MANual
LDIStortion
0 dB gain, for high input levels
LNOise
10 dB gain, for low input levels
MANual
Enables the manual configuration of independent wideband /
narrowband IF gain settings for each segment, drive port and
receiver. See [SENSe<Ch>:]POWer:GAINcontrol and
[SENSe<Ch>:]SEGMent<Seg>:POWer:GAINcontrol.
*RST: LDIS
Example: See [SENSe<Ch>:]POWer:GAINcontrol
Manual operation: See "Wb/Nb IF Gain" on page 621
7.3.14.22 [SENSe:]PAMPlifier...
[SENSe<Ch>:]PAMPlifier<Pt>[:STATe] <Boolean>
Enables or disables the internal preamplifier located in the measurement receiver path
of port <Pt> = 1 or 2.
Suffix:
<Ch>
.
Channel number
<Pt> {1, 2}
Port number
<Pt>=1 addresses the Chapter 4.7.36, "Internal low power spur
reduction amplifier", on page 283 at port 1 (with option
R&S ZNA-B501)
<Pt>=2 addresses the Internal low noise preamplifier at port 2
(with option R&S ZNA-B301)
Other port numbers are invalid and cause an execution error.
Parameters:
<Boolean> Enables (ON) or disables (OFF) the amplifier.
*RST: OFF
Options: R&S ZNA-B501 / R&S ZNA-302
Manual operation: See "Preamp. Gain" on page 478
[SENSe<Ch>:]PAMPlifier2:VALue <Gain>
Sets the gain of the Chapter 4.7.35, "Internal low noise preamplifier", on page 282
located in the measurement receiver path of port 2.
SCPI command reference