Command reference
R&S
®
ZNA
1450User Manual 1178.6462.02 ─ 20
*RST: RRAFter
Example: See SOURce<Ch>:POWer<PhyPt>:CORRection[:ACQuire]
Manual operation: See "Source Leveling/Src. Lev. Method" on page 528
SOURce<Ch>:POWer<PhyPt>:CORRection:COLLect:RRECeiver <arg0>
Enables or disables calibration of the reference receiver together with the source
power calibration.
Note: It is not possible to disable flatness calibration
(SOURce<Ch>:POWer<PhyPt>:CORRection:COLLect:FLATness) and the refer-
ence receiver calibration simultaneously.
Suffix:
<Ch>
.
Calibrated channel number. This parameter is ignored; the verifi-
cation is either enabled or disabled for all channels.
<PhyPt> Calibrated port number. This parameter is ignored; the verifica-
tion is either enabled or disabled for all sources.
Parameters:
<arg0> Enables (ON) or disables (OFF) reference receiver calibration.
*RST: ON
Example: See SOURce<Ch>:POWer<PhyPt>:CORRection:COLLect:
FLATness on page 1448.
SOURce:POWer:CORRection:COLLect:VNETworks <DeEmbNwType>[,
<DeEmbType>]
Defines whether the source flatness cal uses the configured offset de-/embedding to
get the power values at the DUT (instead of the calibrated reference plane).
This setting applies to all physical ports and all channels.
Parameters:
<DeEmbNwType> SENDed | GLOop | OFF | ALL | DIFFerential | PSET | RENorm |
OFFSet | AOFFset
Selects the offset or de-/embedding type to be used, if config-
ured.
ALL means that all available offset and de-/embedding informa-
tion is applied. The <DeEmbType> can be omitted in this case.
*RST: OFF
<DeEmbType> EMBedding | DEEMbedding
Selects between embedding and deembedding for the selected
<DeEmbNwType>.
Must be specified for network types that can be used for embed-
ding and deembedding
Manual operation: See "Embedding" on page 574
SCPI command reference
To Next Page
Loading...
