GUI reference
R&S
®
ZNA
317User Manual 1178.6462.02 ─ 20
Background information
Refer to the following sections:
●
Chapter 4.3.5.1, "Wave quantities", on page 131
●
Chapter 4.3.5.2, "Ratios", on page 132
The notation for wave quantities follows the usual scheme of the vector network ana-
lyzer:
●
The a-waves are the outgoing/transmitted waves at the analyzer's test ports.
●
The b-waves are the incoming/measured waves.
●
The source port for the stimulus signal must be specified in addition.
●
The port number range covers all test ports of the analyzer.
Define
The controls in this section of the dialog allow you to set the "Wave" type, the "Receiv-
ing Port" and the "Source Port".
The latter is only available, if no external source is used (see "Use Generator as
Source" on page 318).
Meas softtool
To Next Page
Loading...
