GUI reference
R&S
®
ZNA
626User Manual 1178.6462.02 ─ 20
Figure 5-31: Stimulus Dialog: Power Sweep
Except for the "Enter & Display" properties, all these parameters can also be set in the
Sweep Softtool. Depending on the channel's Sweep Type, a different set of parameters
can be modified.
Parameter Lin/Log Freq
Sweep
Power Sweep CW Mode
Sweep
Time Sweep
Frequency
Sweep
Enter & Dis-
play
x
x x
Start x
Stop x
Power x
x x
Power Sweep Enter & Dis-
play
x x x
Start
x
Stop
x
Frequency
x x x
Other params Enter & Dis-
play
x
Number of
Points
x x
Enter & Display
The "Enter & Display" combo boxes in the "Frequency Sweep" and "Power Sweep"
sections of the "Stimulus" dialog control how frequency and power values are entered
and displayed.
●
channel base frequency fb/power
●
frequency/power at logical port i
●
source frequency/power at logical port i
●
receiver frequency at logical port i
Channel Config softtool
To Next Page
Loading...
