GUI reference
R&S
®
ZNA
792User Manual 1178.6462.02 ─ 20
Transparent Info Fields
This checkbox enables or disables transparent info fields for markers and trace statis-
tics.
Transparent info fields do not hide an underlying trace.
Remote command:
n.a.
Show Sweep Symbols
This checkbox turns sweep symbols on or off.
Sweep symbols are arrows pointing downward onto the trace. They are displayed if the
sweep time exceeds an upper limit, e.g. if the number of points is high or the measure-
ment bandwidth is low.
Remote command:
n.a.
Use Default Tab for Hardkey
If the checkbox is selected (system default), the Function Keys activate the first
enabled tab of their associated softtool. Otherwise the last used tab is activated.
For background information, see Chapter 5.1, "Function keys and softtools",
on page 298.
Remote command:
n/a
Conductance in Embedding Networks
Changes the presentation of "capacitance C<i> in parallel with resistance R<i>" circuit
blocks in lumped de/embedding networks (see Chapter 4.6.2.3, "Circuit models for 2-
port networks", on page 208 and Chapter 4.6.2.4, "Circuit models for 4-port networks",
on page 210).
If active, the resistance R<i> is displayed and specified as conductance G<i> (=1/
R<i>).
Remote command:
SYSTem:DISPlay:CONDuctancesn/a
Restart: Set all Traces to 0
Defines the behavior of the "Restart Sweep" function (see "Restart Sweep"
on page 512).
If unchecked (factory default) the previous measurement data are preserved. If
checked, they are deleted.
Remote command:
SYSTem:TRESet[:STATe] on page 1517
Number of Trace Colors
Defines the maximum number of trace colors (trace properties for the user defined
color scheme).
Remote command:
SYSTem:DISPlay:TRACes:CCOunt
Setup softtool
To Next Page
Loading...
