R&S ZNA26 - Page 896

Command reference
R&S
®
ZNA
896User Manual 1178.6462.02 ─ 20
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<Position> See list of parameters below.
Default unit: NN
Example:
*RST; :CALC:DLIN 10
Define the position of the horizontal line in the default dB Mag
diagram at +10 dB.
CALC:DLIN:STAT ON
Display the defined horizontal line.
Manual operation: See "Response Value" on page 450
CALCulate<Chn>:DLINe:STATe <Boolean>
Switches the horizontal line on or off.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<Boolean> ON | OFF - horizontal line on or off
*RST: OFF
Example: See CALCulate<Chn>:DLINe
Manual operation: See "Show Horiz. Line" on page 450
7.3.1.5 CALCulate:DTIMe...
Defines the properties and retrieves the results of the skew measurement provided
with the Extended time domain analysis option R&S ZNA-K20.
CALCulate<Chn>:DTIMe:DATA?..................................................................................... 896
CALCulate<Chn>:DTIMe:LIMit:FAIL?...............................................................................897
CALCulate<Chn>:DTIMe:LIMit:FAIL:BEEP....................................................................... 897
CALCulate<Chn>:DTIMe:LIMit:LIMit................................................................................ 898
CALCulate<Chn>:DTIMe:LIMit:STATe.............................................................................. 898
CALCulate<Chn>:DTIMe:POSition...................................................................................898
CALCulate<Chn>:DTIMe:STATe...................................................................................... 898
CALCulate<Chn>:DTIMe:TARGet....................................................................................899
CALCulate<Chn>:DTIMe:DATA? [<Data>]
Queries the results of the skew measurement
Suffix:
<Chn>
.
Channel number used to identify the active trace
SCPI command reference