R&S ZNA50 - Page 1300

Command reference
R&S
®
ZNA
1300User Manual 1178.6462.02 ─ 20
Parameter Type ("Calibration Presetting" dialog)
CPUOsm PUOSM Scalar Vector Mixer
MTOSm | MUOSm | MOSM | MTRL METAS Calibration of type OSM, UOSM, OSM, or TRL
[SENSe<Ch>:]CORRection:COLLect:NFIGure:END
Terminates a noise figure calibration, discarding the acquired calibration data.
A noise figure calibration is initiated using [SENSe<Ch>:]CORRection:COLLect:
NFIGure:STARt and data are aquired using [SENSe<Ch>:]CORRection:
COLLect:NFIGure[:ACQuire]. It must be terminated by one of the commands
[SENSe<Ch>:]CORRection:COLLect:NFIGure:SAVE or
[SENSe<Ch>:]CORRection:COLLect:NFIGure:END.
Suffix:
<Ch>
.
Number of the channel to be noise figure calibrated.
All commands related to a noise figure calibration must use the
same channel number.
Example: See Chapter 8.2, "Condensed programming examples",
on page 1599.
Usage: Event
Options: R&S ZNA-K30
[SENSe<Ch>:]CORRection:COLLect:NFIGure:SAVE
Completes a noise figure calibration, storing and applying the acquired calibration data.
A noise figure calibration is initiated using [SENSe<Ch>:]CORRection:COLLect:
NFIGure:STARt and data are aquired using [SENSe<Ch>:]CORRection:
COLLect:NFIGure[:ACQuire]. It must be terminated by one of the commands
[SENSe<Ch>:]CORRection:COLLect:NFIGure:SAVE or [SENSe<Ch>:
]CORRection:COLLect:NFIGure:END.
In case a noise measurement is missing, an error is reported. In this case, simply per-
form the missing ACQ step, then repeat SAVE.
Suffix:
<Ch>
.
Number of the channel to be noise figure calibrated.
All commands related to a noise figure calibration must use the
same channel number.
Example: See Chapter 8.2, "Condensed programming examples",
on page 1599.
Usage: Event
Options: R&S ZNA-K30
SCPI command reference