R&S ZNA50 - Page 1375

Command reference
R&S
®
ZNA
1375User Manual 1178.6462.02 ─ 20
Parameters:
<ExtClockFreq> Frequency of the external reference clock signal.
Range: See the data sheet of your analyzer.
*RST: 10 MHz
Default unit: Hz
Example:
ROSC EXT
Select the external reference clock as clock source.
ROSC:EXT:FREQ 10MHz
Specify the frequency of the external reference clock.
ROSC:EXT:FREQ?
Query the frequency of the external reference oscillator. The
response is 10000000 Hz.
Manual operation: See "Ext Frequency" on page 813
[SENSe:]ROSCillator:SMA:INPut <SupportedFreqs>
Specifies the frequency of the incoming reference clock signal at the Reference In/Out
SMA connector (see [SENSe<Ch>:]ROSCillator[:SOURce]).
Parameters:
<SupportedFreqs> F100mhz | F1GHz
100 MHz or 1 GHz
*RST: F100mhz
Manual operation: See "Reference I/O (SMA) > In" on page 813
[SENSe:]ROSCillator:SMA:OUTPut <OffOr100MHz>
Defines whether a reference clock signal shall be output to the Reference In/Out SMA
connector.
Ineffective if this connector is used as reference clock source (see [SENSe<Ch>:
]ROSCillator[:SOURce]).
Parameters:
<OffOr100MHz> OFF | F100mhz
No output or 100 MHz
*RST: OFF
Example:
*RST; :ROSC EXT; ROSC:SMA:OUTP F100
Select the Reference In BNC connector as reference clock
source and output the 100 MHz reference clock signal at the
Reference In/Out SMA connector.
Manual operation: See "Reference I/O (SMA) > Out" on page 813
SCPI command reference