R&S ZNA67 - Configure Commands

Command reference
R&S
®
ZNA
1109User Manual 1178.6462.02 ─ 20
The thresholds can either be specified by enum constants for the standard 10–90% or
20–80% rise times, or as integer percentages.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<ThresholdEnum|LowerThreshold>T1_9: 10–90% rise time
T2_8: 20–80% rise time
<integer>: Lower rise time threshold as integer percentage
*RST: T1_9:
<UpperThreshold> Upper rise time threshold as integer percentage
Options: R&S ZNA-K20
Manual operation: See "Start Value / Stop Value" on page 757
7.3.2 CONFigure commands
The CONFigure... commands create and delete channels or traces, assign channel
and trace names, and define the channel sweep order. The commands are device-spe-
cific.
CONFigure:CHANnel:CATalog?..................................................................................... 1109
CONFigure:CHANnel:MEASure:ALL[:STATe]...................................................................1110
CONFigure:CHANnel:MEASure:OPTimized.................................................................... 1110
CONFigure:CHANnel<Ch>[:STATe]................................................................................ 1111
CONFigure:CHANnel<Ch>:MEASure[:STATe]................................................................. 1112
CONFigure:CHANnel<Ch>:NAME..................................................................................1112
CONFigure:CHANnel<Ch>:NAME:ID?............................................................................1113
CONFigure:CHANnel<Ch>:TRACe:REName...................................................................1113
CONFigure:CHANnel<Ch>:TRACe:CATalog?..................................................................1113
CONFigure:TRACe:CATalog?........................................................................................ 1114
CONFigure:TRACe:WINDow?....................................................................................... 1114
CONFigure:TRACe:WINDow:TRACe?............................................................................1115
CONFigure:TRACe<Trc>:CHANnel:NAME?.................................................................... 1115
CONFigure:TRACe<Trc>:CHANnel:NAME:ID?................................................................1115
CONFigure:TRACe<Trc>:NAME.................................................................................... 1116
CONFigure:TRACe<Trc>:NAME:ID?.............................................................................. 1116
CONFigure:TRACe<Trc>:REName.................................................................................1116
CONFigure:CHANnel:CATalog?
Returns the numbers and names of all channels in the current recall set. The response
is a string containing a comma-separated list of channel numbers and names; see
example below. If all channels have been deleted the response is an empty string ("").
SCPI command reference