R&S ZNA67 - Page 1217

Command reference
R&S
®
ZNA
1217User Manual 1178.6462.02 ─ 20
<ModeImpedance> CIMPedance | PIMPedance
CIMPedance (default, if omitted): normalize to a common target
impedance of 50 Ω
PIMPedance: normalize to the individual port reference impe-
dances
See "Renormalization of S-parameters" on page 157.
<Port>, <Port>, ... Physical port numbers
<Port>
Example: Suppose that a full two-port calibration for ports 1 and 2 and
channel 1 has been performed, and that a DUT with two bal-
anced ports is connected. The analyzer measures an arbitrary
mixed mode S-parameter.
MMEM:STOR:TRAC:PORT 1, 'Test_CIMP.s2p',
COMPlex, CIMPedance, 1, 2
Calculate all single-ended S-parameters, renormalize them to
the common target impedance and store them to a two-port
Touchstone file.
MMEM:STOR:TRAC:PORT 1, 'Test_PIMP.s2p',
COMPlex, PIMPedance, 1, 2
Calculate all single-ended S-parameters, renormalize them to to
the individual port reference impedances and store them to a
two-port Touchstone file.
Usage:
Setting only
Manual operation: See "Save" on page 426
7.3.12 OUTPut commands
The OUTPut... commands control the characteristics of the analyzer’s output ports.
OUTPut:ULED:STATe...................................................................................................1217
OUTPut:UPORt:ECBits.................................................................................................1218
OUTPut<Ch>[:STATe]...................................................................................................1218
OUTPut[:STATe]:TYPE................................................................................................. 1218
OUTPut<Ch>:UPORt:SEGMent<Seg>:STATe.................................................................1219
OUTPut<Ch>:UPORt:SEGMent<Seg>[:VALue]...............................................................1219
OUTPut<Ch>:UPORt[:VALue]....................................................................................... 1221
OUTPut:ULED:STATe <ledState>
Configures the "User Defined" LED at the front panel of the R&S ZNA. This is a persis-
tent setting.
Parameters:
<ledState> OFF | GREen | RED | FGReen | FRED
OFF
Switched off
SCPI command reference