R&S ZNA67 - Page 1225

Command reference
R&S
®
ZNA
1225User Manual 1178.6462.02 ─ 20
PROGram[:SELected]:NAME <Program>
Selects the application to be run on the analyzer. At present, only the general parame-
ter PROG is available. This means that PROGram[:SELected]:EXECute can start
any program.
Tip: Use this command in order to avoid problems should the default value change in
future firmware versions.
Parameters:
<Program> PROG
Any program running under Windows or any file that can be
opened with an application program available on the analyzer.
*RST: PROG
Example: See PROGram[:SELected]:EXECute
PROGram[:SELected]:RETVal?
Queries the return value of an application or process started via PROGram[:
SELected]:EXECute.
This will only be successful if preceded by a PROGram[:SELected]:WAIT? query
(see PROGram[:SELected]:WAIT on page 1225).
Example:
See PROGram[:SELected]:EXECute
Usage: Query only
PROGram[:SELected]:WAIT
Locks command execution from the current controller program while a program started
via PROGram[:SELected]:EXECute is running. The analyzer does not execute any
further commands or queries until the program is stopped or paused.
Use PROGram[:SELected]:WAIT? before trying to retrieve the return value of the
executed program (PROGram[:SELected]:RETVal?).
Example:
See PROGram[:SELected]:EXECute
7.3.14 [SENSe:] commands
The [SENSe:]... commands affect the receiver settings of the R&S ZNA.
7.3.14.1 [SENSe:]AVERage...
The [SENSe:]AVERage... commands set sweep averaging parameters. The sweep
average is a noise-reduction technique which consists of calculating each measure-
ment point as an average of the same measurement point over several consecutive
sweeps.
SCPI command reference