R&S ZNA67 - Page 1483

Command reference
R&S
®
ZNA
1483User Manual 1178.6462.02 ─ 20
See also Chapter 6.5.5, "Reset values of the status reporting system", on page 878.
Suffix:
<Lev>
.
Selects one of the two QUEStionable:LIMit registers; see
"STATus:QUEStionable:LIMit<1|2>" on page 872.
Parameters:
<BitPattern> Range: 0 to 65535 (decimal representation)
*RST: n/a
Example:
STAT:QUES:LIM2:PTR 6
Set bits no. 1 and 2 of the
QUEStionable:LIMit2:PTRansition register
STATus:QUEue[:NEXT]?
Queries and at the same time deletes the oldest entry in the error queue. Operation is
identical to that of SYSTem:ERRor[:NEXT]?.
The entry consists of an error number and a short description of the error. Positive
error numbers are instrument-dependent. Negative error numbers are reserved by the
SCPI standard; see section Chapter 9, "Error messages and troubleshooting",
on page 1632.
Example:
STAT:QUE?
Query the oldest entry in the error queue. 0,"No error" is
returned if the error queue is empty.
Usage: Query only
7.3.17 SYSTem commands
The SYSTem... commands provide functions that are not related to instrument perfor-
mance, such as functions for general housekeeping and functions related to global
configurations.
7.3.17.1 SYSTem:COMMunicate...
The SYSTem:COMMunicate... commands provide remote control settings and con-
figure remote (external) devices controlled by the R&S ZNA.
SYSTem:COMMunicate:AKAL:CONNection....................................................................1484
SYSTem:COMMunicate:AKAL:MMEMory[:STATe]........................................................... 1485
SYSTem:COMMunicate:CODec.....................................................................................1485
SYSTem:COMMunicate:GPIB[:SELF]:ADDRess............................................................. 1485
SYSTem:COMMunicate:GPIB[:SELF]:DCLear:SUPPress.................................................1486
SYSTem:COMMunicate:GPIB[:SELF]:INIT:WAIT.............................................................1486
SYSTem:COMMunicate:GPIB[:SELF]:LPORt:ALIGn........................................................1486
SYSTem:COMMunicate:GPIB[:SELF]:RTERminator........................................................ 1486
SYSTem:COMMunicate:NET:HOSTname....................................................................... 1487
SYSTem:COMMunicate:RDEVice:AKAL:ADDRess..........................................................1487
SCPI command reference