R&S ZNA67 - S-Params Tab

GUI reference
R&S
®
ZNA
303User Manual 1178.6462.02 ─ 20
"Meas" softtool tab Channel Mode Required Software Option
(in addition to R&S ZNA-K4)
Intermodulation tab Intermodulation measure-
mentsIntermodulation (frequency
converting)
-
Chapter 5.2.7, "Gain Compres-
sion tab", on page 346
Converter compression
Chapter 5.5.5, "Time Domain tab",
on page 402
Time domain analysis R&S ZNA-K2
Time Gate tab
Power Sensor tab - -
Spectrum tab Spectrum analyzer mode R&S ZNA-K1
5.2.2 S-Params tab
The "S-Params" tab gives access to measurements that are typically used to charac-
terize passive, non-frequency converting DUTs. S-parameters are the basic measured
quantities of a network analyzer. They describe how the DUT modifies a signal that is
transmitted or reflected in forward or reverse direction. S-parameters, and similarly Y-
and Z-parameters, fully characterize a linear DUT.
Background information
Refer to:
●
Chapter 4.3.1, "S-parameters", on page 122
●
Chapter 4.3.3, "Impedance parameters", on page 127
●
Chapter 4.3.3.1, "Converted impedances", on page 127
●
Chapter 4.3.3.2, "Z-parameters", on page 129
●
Chapter 4.3.4, "Admittance parameters", on page 130
●
Chapter 4.3.4.1, "Converted admittances", on page 130
●
Chapter 4.3.4.2, "Y-parameters", on page 130
●
Chapter 4.3.6.3, "Imbalance and common mode rejection", on page 138
●
Chapter 4.3.7, "Stability factors", on page 139
5.2.2.1 Controls on the S-Params tab
The appearance of the "S-Params" tab depends on whether the R&S ZNA is equipped
with the Frequency conversion measurements option R&S ZNA-K4.
Meas softtool