R&S ZNA67 - Wave Tab

GUI reference
R&S
®
ZNA
315User Manual 1178.6462.02 ─ 20
Remote command:
CALCulate<Chn>:TRANsform:IMPedance:RNORmal
5.2.3 Wave tab
Selects wave quantities as measured quantities.
Background information
Refer to Chapter 4.3.5, "Wave quantities and ratios", on page 131.
5.2.3.1 Controls on the Wave tab
The "Setup" button opens the S-Params setup dialog.
The "More Wave Quantities..." button opens the More Wave Quantities dialog which
allows to select an arbitrary wave quantity, e.g. for different source ports or higher port
numbers.
a<i> Source Port <i>, b<j> Source Port <i>
Selects one of the standard 2-port wave quantities a
i
, b
j
for different source ports.
The predefined wave quantities are obtained with different source ports. "a1 Source
Port 1", "b1 Source Port 1" and "b1 Source Port 2" are measured at Port 1 of the ana-
lyzer. "a2 Source Port 2, b2 Source Port 1" and "b2 Source Port 2" are measured at
Port 2 of the analyzer.
Meas softtool