R&S ZNA67 - Traces Softtool; Traces Tab

GUI reference
R&S
®
ZNA
386User Manual 1178.6462.02 ─ 20
You can define the zoom area using touchscreen or mouse. To modify the zoom win-
dow in graphical zoom mode, you can also use the numerical input fields "Max", "Min",
"Start", and "Stop".
Remote command:
DISPlay[:WINDow<Wnd>]:TRACe<WndTr>:ZOOM[:STATe]
Zoom Reset
If a graphical zoom has been applied to the current diagram, this action resets the
zoom area.
Remote command:
DISPlay[:WINDow<Wnd>]:TRACe<WndTr>:ZOOM[:STATe]
Overview On
If a graphical zoom has been applied to the active diagram (and has not been reset,
this button toggles the overview for this diagram.
The overview appears in the upper part of the diagram and shows the original diagram
and the zoom area. You can move the zoomed part of the trace by moving the zoom
area or use the numerical input fields "Max", "Min", "Start", "Stop" to do so.
Remote command:
DISPlay[:WINDow<Wnd>]:TRACe<WndTr>:ZOOM[:STATe]
Max / Min / Start / Stop
Defines the coordinates of the graphical zoom window for the active diagram. "Max"
and "Min" define the response axis range, "Start" and "Stop" define the stimulus axis
range.
The input fields are only enabled if a zoom area was selected before.
Remote command:
DISPlay[:WINDow<Wnd>]:TRACe<WndTr>:ZOOM:BOTTom
DISPlay[:WINDow<Wnd>]:TRACe<WndTr>:ZOOM:STARt
DISPlay[:WINDow<Wnd>]:TRACe<WndTr>:ZOOM:STOP
DISPlay[:WINDow<Wnd>]:TRACe<WndTr>:ZOOM:TOP
5.5 Traces softtool
The "Traces" softtool provides functions for managing traces.
Access: Trace – [Trace Config]
5.5.1 Traces tab
Provides functions to handle traces and diagram areas, and assign traces to channels.
Traces softtool