GUI reference
R&S
®
ZNA
510User Manual 1178.6462.02 ─ 20
●
sending the high voltage level in active state and the low level otherwise ("Active
High"), or vice versa ("Active Low").
Note that pulse generator pulses cannot be indicated using high and low voltage lev-
els.
Remote command:
TRIGger:CHANnel<Ch>:AUXiliary<n>:STYPe
Delay
Specifies the delay of the trigger signal relative to the selected Sequence.
If pulses are used as trigger out signals, the delay is defined relative to the start or end
of the sweep event (see "Position" on page 510 and "Sequence" on page 509)
Remote command:
TRIGger:CHANnel<Ch>:AUXiliary<n>:DELay
Width
If pulses are used as trigger out signals (see "Signal Type" on page 509), this parame-
ter specifies the pulse width.
Remote command:
TRIGger:CHANnel<Ch>:AUXiliary<n>:DURation on page 1529
Position
If pulses are used as trigger out signals (see "Signal Type" on page 509), the pulses
can either indicate the "Start" or "End" position of the related sweep event (see
"Sequence" on page 509). Choose the suitable position setting according to the action
to be triggered.
Note that for the "Pulse Generator" Sequence only the "Start" position can be used.
Remote command:
TRIGger:CHANnel<Ch>:AUXiliary<n>:POSition on page 1530
5.10.4 Sweep Control tab
Allows you to control the sweep execution.
The availability of certain settings depends on the selected Remote Language.
Sweep Softtool
To Next Page
Loading...
