R&S ZNA67 - Cal Softtool; Start Cal Tab

GUI reference
R&S
®
ZNA
515User Manual 1178.6462.02 ─ 20
5.11 Cal softtool
The "Cal" softtool provides all functions related to system error calibration, scalar
power calibration, and "SMARTerCal".
Access: Channel – [Cal]
5.11.1 Start Cal tab
The "Start Cal" tab provides access to all functions for automatic or manual calibration.
Calibration of the R&S ZNA is a fully guided process.
Background information
Refer to the following sections:
●
Chapter 4.5, "Calibration", on page 158
●
Chapter 4.5.5, "Automatic calibration", on page 179
●
Chapter 4.5.6, "Scalar power calibration", on page 191
●
Chapter 4.5.7, "SMARTerCal", on page 197
●
Chapter 4.1.6, "Data flow", on page 93
5.11.1.1 Measurement modes and default calibration setup
When you open the Calibration wizard, the Calibration setup dialog, or the Calibrate All
dialog for the first time, the analyzer determines the preferred calibration setup based
on:
●
the channel's (or channels') measurement mode (or modes)
●
the channel's traces
●
whether a power meter is connected
The channel's (or channels') calibration setup is either written to the recall set automat-
ically, or you are asked to select between several reasonable setups (non-"Quick Start"
actions only).
Cal softtool