GUI reference
R&S
®
ZNA
693User Manual 1178.6462.02 ─ 20
Use the "Info" button to get additional information about the selected tool.
Note: Define at least two Balanced panel before running the modeling tool.
5.14.8 Ground Loop tab
Allows you to specify a 1-port ground loop deembedding/embedding network.
Such a network is either defined
●
via its S-parameter stored in a one-port Touchstone file (*.s1p) or
●
by selecting a predefined lumped element model (Shunt L or Shunt C) and specify-
ing the available parameters (resistance/inductance or resistance/capacitance)
Use the complementary dock widget to activate or deactivate ground loop dembedding
and embedding (see Chapter 5.14.1.6, "Ground Loop panel", on page 658).
If multiple port groups (DUTs) are configured and Ground Loop per Port Group is
enabled, use the dock widget to select the port group whose ground loop network shall
be configured.
Background information
Refer to Chapter 4.6.2.7, "Ground loop de-/embedding", on page 214.
If the "Fixture Simulator" is disabled for the related channel (see "Fixture Simulator"
on page 600), this tab is inactive, i.e. all controls except the "Overview" button are
grayed out.
Overview
See "Overview" on page 662.
Offset Embed softtool
To Next Page
Loading...
