R&S ZNA67 - Page 708

GUI reference
R&S
®
ZNA
708User Manual 1178.6462.02 ─ 20
5.15.1.1 Basic Recall Set functions
To create a recall set based on the current analyzer configuration, select Save. To
open an existing recall set, select Open Recall.... To create an additional setup, select
New.
The R&S ZNA supports two recall set file formats
●
znxml (default)
XML based file format, introduced with the R&S ZNA
●
znx
Binary file format, originating from the R&S ZNB
New
Adds a new setup. The default names for new setups are "Set1", "Set2" etc. Recall
sets are accessible via tabs in the diagram area:
Tip: To open an existing recall set, use "Open Recall...". To rename a setup, use
"Save..."
Remote command:
MEMory:DEFine
Open Recall...
Loads a recall set from a file (*.znxml|*.znx).
Opens the Open Dialog with suitable file filters.
Note: In case the recall set could only be loaded after adjusting some incompatible
settings, the info message "The setup data changed while loading" is displayed.
This may happen, for example, if you attempt to load a recall set of a different
R&S ZNA model or with different optioning.
Remote command:
MMEMory:LOAD:STATe
Save
Saves the active recall set to a file (*.znxml|*.znx) .
Displays the Save Dialog that allows you to specify a file name and location for the
recall set file.
Remote command:
MMEMory:STORe:STATe
Recent Files
The buttons are labeled with the last recall sets which were stored in the current or in
previous sessions. They open the corresponding recall set.
File Print softtool