GUI reference
R&S
®
ZNA
711User Manual 1178.6462.02 ─ 20
Note that the diagram content to be copied can be configured in the Content tab >
"Print Charts" group of the "Printer Setup" dialog. E.g., if you select "All diagrams on
their own page" there, then only the content of the active diagram is copied to clip-
board. If you select "No diagram at all", then "To Clipboard" is disabled.
5.15.4 Printer Setup dialog
The "Printer Setup" dialog specifies how the diagram content of, and/or other informa-
tion on the active recall set is printed. Printer options are specified in three tabs. The
lower part of the dialog shows a preview of the print.
Access: System – [File Print] > "Print" > "Print..."
The HCOPy... commands provide the printer settings; see Chapter 7.3.7, "HCOPy
commands", on page 1165.
5.15.4.1 Content tab
The "Content" tab allows you to select the diagram content to be printed.
File Print softtool
To Next Page
Loading...
