GUI reference
R&S
®
ZNA
770User Manual 1178.6462.02 ─ 20
5.18.1 Diagram tab
Selects a diagram as the active diagram, defines a title, deletes or adds diagrams and
arranges them on the screen. Many of the functions are unavailable if the active recall
set contains only one diagram.
Related settings
Use the icons in the toolbar to add diagrams and traces. Use the "Zoom Active Trc"
icon to zoom into a rectangular portion inside a diagram. See also Chapter 3.3.5, "Han-
dling diagrams, traces, and markers", on page 62 and Chapter 3.3.7.1, "Using the
graphical zoom", on page 70.
Active Diagram
Selects the active diagram.
Each recall set screen can display several diagrams simultaneously, each with a vari-
able number of traces. One of these diagrams and traces is active at each time. The
diagram number (or name) in the upper right corner of the active diagram is highligh-
ted. At the same time, the active trace is highlighted in the trace list on top of the active
diagram (Trc3 in the figure below):
The analyzer provides several tools for activating diagrams:
●
tap on a point in the diagram to activate the diagram including the last active trace
in the diagram.
●
tap on a trace list to activate the trace including the corresponding diagram.
●
Some of the functions of the Traces tab activate a particular trace including the cor-
responding diagram.
Remote command:
DISPlay[:WINDow<Wnd>]:TRACe<WndTr>:CATalog?
Display softtool
To Next Page
Loading...
