GUI reference
R&S
®
ZNA
788User Manual 1178.6462.02 ─ 20
Global Settings
The two buttons reset all directory settings (e.g. the directories for storing trace data,
limit lines, calibration data...) and all settings in the "Printer Setup" dialog to default val-
ues. See Chapter 5.15.4, "Printer Setup dialog", on page 711.
Remote command:
n/a
Preset Configuration
Specifies whether the preset action performs a factory preset or restores a user preset
file. A user preset file is an arbitrary recall set file (*.znxml|*.znx), that can be cre-
ated from the active setup using System – [File Print] > "Save...". If the current user
preset file is not found (e.g. because it was deleted or moved), System – [Preset] ini-
tiates a factory preset.
The preset configuration applies to:
●
the System – [Preset] hardkey (if "Immediate Preset" on page 843 is selected)
●
the Preset button
●
the remote commands *RST and SYSTem:PRESet (if "Align *RST to User Defined
Preset" is selected in the Remote Preset Configuration section).
Furthermore, the user preset file is used as a template, whenever New recall set files
are created from the GUI.
Remote command:
SYSTem:PRESet:USER:NAME
SYSTem:PRESet:USER[:STATe]
Start in Preset
If this option is active, the R&S ZNA FW always starts with the configured Preset Con-
figuration. Otherwise it starts with the previous state, i.e. the settings that were persis-
ted during the previous shutdown.
Remote command:
SYSTem:PRESet:STARt
Calibration tab
Provides general system error correction (calibration) settings.
Setup softtool
To Next Page
Loading...
