GUI reference
R&S
®
ZNA
811User Manual 1178.6462.02 ─ 20
Most of the service functions require a service level > 0 that is protected by a pass-
word. Those service functions should be used by a Rohde & Schwarz service repre-
sentative only. Refer to the service manual for more information.
Password
Enter a password here to activate the required service level.
Remote command:
SYSTem:PASSword[:CENable]
Service Function
Identifier of the service function in "dotted textual" (example: sw.common.mem-
ory_usage) or "dotted decimal" (example: 0.1.18.0) representation.
Remote command:
DIAGnostic:SERVice:SFUNction
5.19.2 Freq. Ref. tab
Selects a reference signal for synchronization between the R&S ZNA and external
devices. A common reference frequency is advisable to ensure frequency accuracy
and frequency stability in the test setup.
Setup softtool
To Next Page
Loading...
