R&S ZNA67 - Remote Settings Tab

GUI reference
R&S
®
ZNA
813User Manual 1178.6462.02 ─ 20
Reference Clock Source "Reference Out (BNC)"
"Internal" 10 MHz
"External (BNC)" 10 MHz
"External (SMA)" Off
Ext Frequency
Specifies the frequency of the external reference clock signal at Reference In.
Remote command:
[SENSe:]ROSCillator:EXTernal:FREQuency
Reference I/O (SMA) > Out
Defines whether a 100 MHz reference clock signal is output to the Reference In/Out
SMA connector.
Ineffective and disabled if this connector is used as reference clock source.
Remote command:
[SENSe:]ROSCillator:SMA:OUTPut
Reference I/O (SMA) > In
Specifies the frequency of the incoming reference clock signal at the Reference In/Out
SMA connector (100 MHz or 1 GHz).
Effective and enabled if and only if the Reference In/Out SMA connector is used as
reference clock source.
Remote command:
[SENSe:]ROSCillator:SMA:INPut
5.19.3 Remote Settings tab
Configures the remote control interfaces of the R&S ZNA.
Setup softtool