GUI reference
R&S
®
ZNA
836User Manual 1178.6462.02 ─ 20
a wave, b wave, Source
Define a physical port by assigning its reference receiver, measurement receiver and
generator, respectively.
The receivers and generators can be freely assigned, but without reusing the same
(original) physical port in different (redefined) ports.
Remote command:
[SENSe:]UDSParams<Pt>:PARam
[SENSe:]UDSParams:ACTive
5.19.8 Generic Device tab
The "Generic Devices" tab allows you to define and configure VISA-capable external
devices that are not natively supported by the analyzer firmware.
Background information
Refer to Chapter 4.7.40, "Generic devices", on page 292.
1. Use "Generic Device..." to open the External Generic Devices dialog, which allows
you to set up the VISA connection to the device and make it a part of the system
configuration.
2. Use "Generic Device Config..." to open the External Generic Device Config dialog,
which allows you to define the channel-specific command sequences that are sent
to the configured devices.
5.19.8.1 External Generic Devices dialog
The "External Generic Devices" dialog allows you to set up the communication to an
external VISA-capable device that is not natively supported by the analyzer firmware.
Setup softtool
To Next Page
Loading...
