R&S ZNA67 - Calculate Commands

Command reference
R&S
®
ZNA
884User Manual 1178.6462.02 ─ 20
● MMEMory commands......................................................................................... 1176
● OUTPut commands.............................................................................................1217
● PROGram commands.........................................................................................1222
● [SENSe:] commands...........................................................................................1225
● SOURce commands........................................................................................... 1408
● STATus commands............................................................................................. 1480
● SYSTem commands............................................................................................1483
● TRACe commands..............................................................................................1519
● TRIGger commands............................................................................................1522
● New commands for R&S ZNA.............................................................................1532
7.3.1 CALCulate commands
The CALCulate... commands perform post-acquisition data processing. Functions
in the SENSe subsystem are related to data acquisition, while the CALCulate subsys-
tem operates on the data acquired by a SENSe function.
7.3.1.1 CALCulate:CLIMits...
The CALCulate:CLIMits... commands control the composite limit check.
CALCulate:CLIMits:FAIL?
Returns a 0 or 1 to indicate whether or not a global, composite limit check on several
traces has failed.
Since V2.20 of the R&S ZNA FW the result is automatically recalculated whenever a
relevant setting is changed, i.e. a subsequent query will return the updated limit viola-
tion state.
Example:
*RST; CALC:LIM:CONT 1 GHZ, 2 GHZ
Define an upper limit line segment in the stimulus range
between 1 GHz and 2 GHz, using default response values.
CALC:LIM:STAT ON; FAIL?
Switch the limit check on and query the result.
CALC:CLIM:FAIL?
Query the result for the composite limit check. As only one trace
is tested, the response should be equal to the previous
response.
Usage: Query only
Manual operation: See "Global Check" on page 434
7.3.1.2 CALCulate:CALValidate...
Commands related to Calibration validation.
CALCulate:CALValidate:CHARacteriza <String>
Selects the CalU characterization to be used for the cal validation.
SCPI command reference