R&S ZNA67 - Parameters

Command reference
R&S
®
ZNA
886User Manual 1178.6462.02 ─ 20
Parameters:
<Standard> OPEN | SHORt | MATCh
7.3.1.3 CALCulate:DATA...
The CALCulate:DATA... commands provide access to the results of a measure-
ment.
Data format
The trace data is transferred in either ASCII or block data (REAL) format, depending
on the FORMat[:DATA] setting. If block data format is used, it is recommended to
select EOI as a receive terminator (SYSTem:COMMunicate:GPIB[:SELF]:
RTERminator EOI).
CALCulate:DATA:ALL?................................................................................................... 886
CALCulate:DATA:DALL?.................................................................................................887
CALCulate:DATA:TRACe................................................................................................ 887
CALCulate<Ch>:DATA:CALL...........................................................................................887
CALCulate<Ch>:DATA:CALL:CATalog?............................................................................889
CALCulate<Ch>:DATA:CHANnel:ALL?.............................................................................889
CALCulate<Ch>:DATA:CHANnel:DALL?.......................................................................... 889
CALCulate<Ch>:DATA:MDATa:INTerpolate.......................................................................890
CALCulate<Ch>:DATA:SGRoup?.................................................................................... 890
CALCulate<Chn>:DATA..................................................................................................890
CALCulate<Chn>:DATA:NSWeep[:LAST]?....................................................................... 893
CALCulate<Chn>:DATA:NSWeep:COUNt?.......................................................................894
CALCulate<Chn>:DATA:NSWeep:FIRSt?.........................................................................894
CALCulate<Chn>:DATA:STIMulus?................................................................................. 895
CALCulate:DATA:ALL? <Format>[, <RecallSet>]
Reads the current response values of all traces of the referenced recall set.
Query parameters:
<Format> FDATa | SDATa | MDATa
Output format for the S-parameter data, see
CALCulate<Chn>:DATA.
<RecallSet> Recall set name; if omitted the active recall set is used
Return values:
<Data> Response values either in ASCII or block data format, depend-
ing on the current FORMat[:DATA] setting.
Example: See CALCulate<Chn>:DATA
Usage: Query only
SCPI command reference