R&S ZNA67 - Calculate:fmodel:sfd<Ph_Pt>:Coupon:measure; Calculate:fmodel:sfd<Ph_Pt>:Coupon:measure:filename:clear

Command reference
R&S
®
ZNA
956User Manual 1178.6462.02 ─ 20
The coupon type can be selected using CALCulate:FMODel:SFD<Ph_pt>:
COUPon:TYPE.
Suffix:
<Ph_pt>
.
This suffix is ignored.
Parameters:
<String> Path to the Touchstone file, either absolute or relative to the
selected working directory (CALCulate:FMODel:DIRectory).
Manual operation: See "Load File / 1x Open Preset / 1x Short Preset" on page 677
CALCulate:FMODel:SFD<Ph_pt>:COUPon:MEASure:FILename:CLEar
Invalidates the file path previously set using CALCulate:FMODel:SFD<Ph_pt>:
COUPon:MEASure:FILename.
Suffix:
<Ph_pt>
.
This suffix is ignored.
Usage: Event
Manual operation: See "Load File / 1x Open Preset / 1x Short Preset" on page 677
CALCulate:FMODel:SFD<Ph_pt>:COUPon[:STATe] <Boolean>
For a fixture modeling with the SFD tool, this command allows to specify the ports to
which the test coupon is connected.
This has to be defined before measuring the test coupon (using CALCulate:FMODel:
SFD<Ph_pt>:DUT:MEASure).
Suffix:
<Ph_pt>
.
Physical port number
Parameters:
<Boolean> 1 (ON, true) if the test coupon is connected to port <Ph_pt>, 0
(OFF, false) otherwise
Manual operation: See "Active" on page 677
CALCulate:FMODel:SFD<Ph_pt>:COUPon:TYPE <CouponType>
Sets/gets the coupon type to be measured for a fixture modelling with the SFD tool.
Suffix:
<Ph_pt>
.
This suffix is ignored.
Parameters:
<CouponType> SYMMetric2x | OPEN1x | SHORt1x
Manual operation: See "Coupon Type" on page 676
SCPI command reference