Command reference
R&S
®
ZNA
965User Manual 1178.6462.02 ─ 20
TRACking - Repeat calculation for each measured trace and
apply the correction.
*RST: 0 dB/MHz
Example: See CALCulate<Chn>:LDEViation:AUTO on page 963
Manual operation: See "On" on page 429
CALCulate<Chn>:LDEViation:SLOPe <Slope>
Defines the slope of the regression line for the linearity deviation calculation.
Suffix:
<Chn>
.
Channel number used to identify the active trace.
Parameters:
<Slope> Slope of the regression line
Range: The range depends on the trace format. For the
default trace: -1015 dB/MHz to +1015 dB/MHz.
Increment: 10E-4 dB/MHz
*RST: 0 dB/MHz
Example: See CALCulate<Chn>:LDEViation:AUTO on page 963
Manual operation: See "Slope" on page 430
7.3.1.13 CALCulate:LIMit...
The CALCulate:LIMit... commands define the limit lines and control the limit
check.
CALCulate:LIMit:CIRCle:FAIL:ALL?................................................................................. 966
CALCulate:LIMit:FAIL:ALL?.............................................................................................966
CALCulate:LIMit:FAIL:DATA?.......................................................................................... 966
CALCulate<Chn>:LIMit:CIRCle[:STATe]............................................................................967
CALCulate<Chn>:LIMit:CIRCle:CLEar..............................................................................967
CALCulate<Chn>:LIMit:CIRCle:DATA...............................................................................967
CALCulate<Chn>:LIMit:CIRCle:DISPlay[:STATe]............................................................... 968
CALCulate<Chn>:LIMit:CIRCle:FAIL?.............................................................................. 968
CALCulate<Chn>:LIMit:CIRCle:SOUNd[:STATe]................................................................968
CALCulate<Chn>:LIMit:CLEar.........................................................................................969
CALCulate<Chn>:LIMit:CONTrol[:DATA]...........................................................................969
CALCulate<Chn>:LIMit:CONTrol:SHIFt............................................................................ 970
CALCulate<Chn>:LIMit:DATA..........................................................................................970
CALCulate<Chn>:LIMit:DCIRcle[:STATe].......................................................................... 971
CALCulate<Chn>:LIMit:DCIRcle:CLEar............................................................................971
CALCulate<Chn>:LIMit:DCIRcle:DATA.............................................................................971
CALCulate<Chn>:LIMit:DCIRcle:DISPlay[:STATe]............................................................. 972
CALCulate<Chn>:LIMit:DELete:ALL.................................................................................972
CALCulate<Chn>:LIMit:DISPlay[:STATe].......................................................................... 972
CALCulate<Chn>:LIMit:FAIL?..........................................................................................973
CALCulate<Chn>:LIMit:LOWer[:DATA]............................................................................. 973
SCPI command reference
To Next Page
Loading...
