EasyManua.ls Logo

Range Rover L322 - Page 91

Range Rover L322
494 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DESCRIPTION AND OPERATION
4.66 RANGE ROVER
HEATED REAR WINDOW (HRW)
DESCRIPTION
General
Operation of the Heated Rear Window (HRW) is controlled by the Automatic Temperature
Control (ATC) ECU via the non latching HRW switch. After 10 minutes of operation, (when
ambient temperature is –15 °C (5 °F) or above) or 17 minutes (when ambient temperature
is less than –15 °C (5 °F)), the ATC ECU operates the HRW at low power for 60 minutes.
During the 60 minutes, the ATC ECU cycles the HRW relay off for 80 seconds and on for 40
seconds. If the HRW switch is pressed again during the low power phase, the ATC ECU
returns the HRW to full power by keeping the HRW relay energised for 5 minutes. At the end
of the 5 minutes the low power phase is repeated.
The ATC ECU outputs a K bus message when the HRW is active. The message allows the
navigation computer to compensate for the effect of the magnetic field generated when the
HRW is active. The BCU transfers the message onto the P bus for the door modules, which
activate the door mirror heaters together with the HRW.
OPERATION
Power Distribution
Feed from the positive battery terminal (C0192) is supplied to fusible link 5 and fuse 53 of
the passenger compartment fuse box (C0632) on an R wire. Fusible link 5 (C0588) is
connected to fuse 9 of the rear fuse box (C2024) by an R wire. Fuse 9 provides a constant
battery feed to the HRW relay, which is also located in the rear fuse box.
Fuse 53 of the passenger compartment fuse box (C0583) provides a constant battery feed
to the ignition switch (C0099 on Td6 vehicles, C0028 on V8 vehicles) on an R wire. When
the ignition switch is turned to the 'ignition' position, current flows across the switch (C0099
on Td6 vehicles, C0028 on V8 vehicles) to fuse 2 of the passenger compartment fuse box
(C0585) on a G wire. Fuse 2 (C0587) provides an ignition feed to the HRW relay coil (C2022)
on a GY wire. The earth path for the relay coil (C2022) is controlled by the ATC ECU (C1629)
on a UN wire.
HRW
When the HRW switch is pressed, a momentary earth path (C1630) is created on an N wire.
If all operational conditions are met (see 'Description' above), the ATC ECU energises the
HRW relay. The energised HRW relay (C2021) provides a feed to the HRW (C0381) on a B
wire. The HRW (C0382) is earthed on an N wire.