Rantopad MXX - Backlight Controls and Effects; Backlight FN Key Combinations; RGB Backlight Effect Modes

Backlight:
FN+F10 choose an RGB backlight/single color backlight as backlight
FN+F11 switch light effect mode of backlight
FN+PAUSE stop/start dynamic light effect of backlight (to set current backlight color)
FN+PAGE DN Adjusts the lighting speed of the backlight. With 5 levels in total, each press will add
one level and will reset to minimum when activated again after the maximum setting. Factory
setting is set to maximum level.
FN+INSERT/DELETE, adjust backlight brightness. Press and hold will increase or decrease brightness.
There are 21 levels in total (including off). Factory setting is set to maximum with minimum level
being off.
Light effect mode details of RGB backlight
No.
Name
Description
1
RGB H
Wave
RGB color wave from left to right
2
RGB V
Wave
RGB color wave from top to bottom
3
RGB
Breath
Random RGB color breath
4
Spectrum
Random RGB color turn on and cycle like spectrum
5
RGB
Starlight
Random RGB color, random time and random effect turn on
6
RGB Scan
Random RGB color scan from left to right, then from right to left and
cycle
7
Bubble
Random RGB color spread out from two points
8
Mixture
Two random colors moves from two sides to the other and two colors
will fade and mix when met. After 3-4 routines, colors vanish from
middle to side and cycle like this.
9
off
Turn off RGB backlight