Chapter 2: DX2 Series
12
Number Component Function
Two LEDs Indicate two channels' status.
Supported detector/switch types:
At a minimum, a discrete detector/switch is required for DX2-CC2 to
work properly. The types of discrete detectors/switches that can be
connected to DX2-CC2 include those for:
Door open/closed detection
Door lock detection
Smoke detection
Vibration detection
When using third-party probes, you must test them with DX2-CC2 to
ensure they work properly.
Important: Integration and testing for third-party detectors/switches
is the sole responsibility of the customer. Raritan cannot assume
any liability as a result of improper termination or failure (incidental
or consequential) of third-party detectors/switches that customers
provide and install. Failure to follow installation and configuration
instructions can result in false alarms or no alarms. Raritan makes
no statement or claim that all third-party detectors/switches will
work with Raritan's contact closure sensors.
To make DX2-CC2 work properly:
1. Connect 1 to 2 contact closure detectors/switches to DX2-CC2. See
Connecting Detectors/Switches to DX2-CC2
(on page 13).
2. Connect DX2-CC2 to a Raritan or Legrand product that supports
Raritan sensor packages, such as Raritan's PX3 or Legrand PDU.
3. Log in to the application of Raritan or Legrand product where
DX2-CC2 is being connected, and configure Normally Open or
Normally Closed for DX2-CC2.
To Next Page
Loading...