Raritan DRX Series - DX2-CC2 Contact Closure Sensor Leds

Chapter 2: DX2 Series
16
Option Description
Normally Open
Factory default.
 It is considered normal when the
switch/detector connected to DX2-CC2 is
open.
 When the switch/detector turns closed, an
alarm is shown.
Normally Closed
 It is considered normal when the
switch/detector connected to DX2-CC2 is
closed.
 When the switch/detector turns open, an
alarm is shown.
Alarm of DX2-CC2 is shown on the following:
 DX2-CC2 LED. See
DX2-CC2 Contact Closure Sensor LEDs (on
page 16).
 Software app
lication of the Raritan or Legrand product where this
DX2-CC2 is connected. For details, refer to the user guide or online
help of your Raritan or Legrand product.
DX2-CC2 Contact Closure Sensor LEDs
LED description in this section applies to all of Raritan's contact
closure sensors, including DPX-CC2-TR, DX series and DX2-CC2. See
Available DX Sensor Packages (on page 20) and DPX Contact
Closure Sensors (on page 57).
LEDs indicate states of detectors/switches connected to the contact
closure sensor channels.
The LED is lit when the associated detector/switch enters the "alarmed"
state. See
Configuring DX2-CC2's Normal State (on page 15) for how to
set the Normal state of DX2-CC2.
The meaning of a lit LED varies depending on the Normal state settings.
 When the Normal state is set to Normally Closed (N.C):
LED Sensor state
Off Closed
Lit Open