Chapter 5: DPX2 Series
48
Disconnecting a DPX2 Sensor
You can remove any individual DPX2 sensor from the sensor cable
whenever needed.
To disconnect a DPX2 sensor:
1. Press the latch of the cable connector so that the other side of the
latch slightly goes up.
2. Pull the sensor away.
3. Connect any DPX2 sensor back to this free head connector, or move
all subsequent DPX2 sensors that follow it on the same sensor cable
to prior head connectors.
Warning: The final step is required, or all subsequent DPX2 sensors
no longer work properly. For example, after removing the sensor from
the 2nd head connector, you must either add a DPX2 sensor back to
the 2nd head connector, or move the sensor attached to the 3rd head
connector to the 2nd head connector.
To Next Page
Loading...