Chapter 6: DPX Series
65
Cable Water Sensor
The cable water sensor is in the shape of a cable so it can be flexibly
placed, twisted or wrapped around a location where water may drip,
such as a ceiling tile, water pipe or the floor.
Raritan provides two types of cable water sensors. The only difference is
their cable length.
DPX-WSC-35: 3.5 meters (11.5 feet).
DPX-WSC-70: 7 meters (23 feet).
Number Item
Cable-shaped water detector.
Wires to connect to the contact closure sensor.
You need a minimum of 30 cm wires to prevent the
contact closure sensor from being damaged by floor
water (if any). Below are the wire length limitations:
Minimum: 30 cm (11.8 inches)
Maximum: 150 cm (59 inches)
To Next Page
Loading...