Raritan PMC-1000 - Yellow- or Red-Highlighted Sensors

Chapter 3: Using the Web Interface
121
Yellow- or Red-Highlighted Sensors
The BCM2 highlights those sensors that enter the abnormal state with a
yellow or red color. Note that numeric sensors can change colors only
after you have enabled their thresholds.
Tip: When an actuator is turned ON, it is also highlighted in red for
drawing attention.
For concepts of thresholds, deassertion hysteresis and assertion timeout,
see
Sensor Threshold Settings (on page 576).
In the following table, "R" represents any numeric sensor's reading. The
symbol <= means "smaller than" or "equal to."
Sensor status
Color
States shown in
the interface
Description
Unknown unavailable Sensor state or readings cannot be detected.
unmanaged Sensors are not being managed. See
Managed vs
Unmanaged Sensors/Actuators
(on page 122).
Normal normal
 Numeric or state sensors are within the normal range.
-- OR --
 No thresholds have been enabled for numeric sensors.
Warning above upper
warning
Upper Warning threshold < "R" <= Upper Critical
threshold
below lower
warning
Lower Critical threshold <= "R" < Lower Warning
threshold
Critical above upper
critical
Upper Critical threshold < "R"
below lower
critical
"R" < Lower Critical threshold