Chapter 3: Using the Web Interface
a. Click Add. The "Add Privileges to Role XXX" dialog appears,
where XXX is the role name.
b. Select the permission you want from the Privileges list.
c. If the permission you selected contains any argument setting,
the Arguments list is shown to the right, such as the Switch
Actuator permission. Then select one or multiple arguments.
d. Click Add to add the selected permission (and arguments if any).
e. Repeat Steps
a
to
d
until you add all necessary permissions.
8. To change a specific permission's arguments, do this:
a. Select the permission by clicking it.
b. Click Edit. The "Edit arguments of privilege XXX" dialog appears,
where XXX is the privilege name.
Note: If the permission you selected does not contain any arguments,
the Edit button is disabled.
c. Select the argument you want. You can make multiple
selections.
d. Click OK.
9. Click OK.
To Next Page
Loading...
