Raritan PMC-1000 - Configuring Network Services

Chapter 3: Using the Web Interface
192
Configuring Network Services
The BCM2 supports the following network communication services.
HTTPS and HTTP enable the access to the web interface. Telnet and SSH
enable the access to the command line interface. See
Using the
Command Line Interface (on page 355).
By default, SSH is enabled, Telnet is disabled, and all TCP ports for
supported services are set to standard ports. You can change default
settings if necessary.
Note: Telnet access is disabled by default because it communicates
openly and is thus insecure.
Submenu command
Refer to
HTTP
Changing HTTP(S) Settings
(on page 193)
SNMP
Configuring SNMP Settings
(on page 194)
SMTP Server
Configuring SMTP Settings
(on page 196)
SSH
Changing SSH Settings
(on page 198)
Telnet
Changing Telnet Settings
(on page 199)
Modbus
Changing Modbus Settings
(on page 199)