Chapter 3: Using the Web Interface
Setting the Date and Time
Set the internal clock on the BCM2 device manually, or link to a Network
Time Protocol (NTP) server.
Note: If you are using Sunbird's Power IQ to manage the BCM2, you must
configure Power IQ and the BCM2 to have the same date/time or NTP
settings.
To set the date and time:
1. Choose Device Settings > Date/Time.
2. Click the Time Zone field to select your time zone from the list.
3. If the daylight saving time applies to your time zone, verify the
Automatic Daylight Saving Time Adjustment checkbox is selected.
If the daylight saving time rules are not available for the selected
time zone, the checkbox is not configurable.
4. Select the method for setting the date and time.
Customize the date and time
Select User Specified Time.
Type values in the Date field using the yyyy-mm-dd format, or click to select
a date. For details, see
(on page 228).
Type values in the Time field using the hh:mm:ss format, or click to adjust
values.
The time is measured in 12-hour format so you must correctly specify AM or PM
by clicking the AM or PM button.
To Next Page
Loading...
