Chapter 3: Using the Web Interface
Default message when the event =
TRUE
Default message when the event =
FALSE
lower warning threshold
Power Meter Controller >
Power Meter >
[POWERMETER] > Circuit >
[CIRCUIT] > Pole >
[CIRCUITPOLE] > Sensor >
[PDUPOLESENSOR] > Below
lower critical threshold
Sensor '[PDUPOLESENSOR]' on pole
'[CIRCUITPOLE]' of panel
'[POWERMETER]' circuit '[CIRCUIT]'
asserted 'below lower critical' at
[SENSORREADING]
[SENSORREADINGUNIT].
Sensor '[PDUPOLESENSOR]' on
pole '[CIRCUITPOLE]' of panel
'[POWERMETER]' circuit '[CIRCUIT]'
deasserted 'below lower critical' at
[SENSORREADING]
[SENSORREADINGUNIT].
Available Actions
The BCM2 comes with three built-in actions, which cannot be deleted.
You can create additional actions for responding to different events.
Built-in actions:
•
System Event Log Action:
This action records the selected event in the internal log when the
event occurs.
•
System SNMP Notification Action:
This action sends SNMP notifications to one or multiple IP addresses
after the selected event occurs.
Note: No IP addresses are specified for this notification action by
default so you must enter IP addresses before applying this action to
any event rule. See
Editing or Deleting a Rule/Action
(on page 280).
Any changes made to the 'SNMP Notifications' section on the SNMP
page will update the settings of the System SNMP Notification Action,
and vice versa. See
Configuring SNMP Settings
(on page 194).
To Next Page
Loading...
