Chapter 3: Using the Web Interface
The name of the webcam that BCM2 detects later, if an
additional webcam is connected.
This is the folder where the snapshots captured by the second
webcam are stored.
The second webcam's default name is "Webcam 2".
Changing this webcam's name also changes the second
snapshots folder's name.
If the webcam's location is important, you can customize the
webcam's name based on its location when configuring
BCM2 to save snapshots onto a remote server.
Note: It is suggested to customize a webcam's name prior to saving
snapshots on the remote server. In case you change the webcam's name
after saving any snapshots, BCM2 will create a new folder with the new
webcam name while keeping the old folder with the old name.
To Next Page
Loading...
