Raritan PMC-1000 - Date and Time Settings; Default Measurement Units

Chapter 5: Using the Command Line Interface
366
Date and Time Settings
This command shows the current date and time settings on the BCM2
device.
#
show time
To show detailed information, add the parameter "details" to the end of
the command.
#
show time
details
Default Measurement Units
This command shows the default measurement units applied to the
BCM2 web and CLI interfaces across all users, especially those users
authenticated through remote authentication servers.
#
show user defaultPreferences
Note: If a user has set his/her own preferred measurement units or the
administrator has changed any user's preferred units, the web and CLI
interfaces show the preferred measurement units for that user instead
of the default ones after that user logs in to the BCM2. See
Existing User
Profiles (on page 374) for the preferred measurement units for a specific
user.