Raritan PMC-1000 - Authentication Settings

Chapter 5: Using the Command Line Interface
373
Authentication Settings
General authentication settings:
This command displays the authentication settings of the BCM2,
including both LDAP and Radius settings.
#
show authentication
One LDAP server's settings:
To show the configuration of a specific LDAP server, assign the desired
LDAP server with its sequential number in the command. To get detailed
information, add "details" to the end of the command.
#
show authentication ldapServer <server_num>
-- OR --
#
show authentication ldapServer <server_num> details
One Radius server's settings:
To show the configuration of a specific Radius server, assign the desired
Radius server with its sequential number in the command. To get
detailed information, add "details" to the end of the command.
#
show authentication radiusServer <server_num>
-- OR--
#
show authentication radiusServer <server_num> details
Variables:
• <server_num> is the sequential number of the specified
authentication server on the LDAP or Radius server list.
Displayed information:
• Without specifying any server, BCM2 shows the authentication type
and a list of both LDAP and Radius servers that have been
configured.
• When specifying a server, only that server's basic configuration is
displayed, such as IP address and port number.