Raritan PMC-1000 - Time Configuration Commands

Chapter 5: Using the Command Line Interface
414
Examples
This section illustrates several network configuration examples.
Example 1 - Networking Mode
The following command enables the wired networking mode.
config:#
network mode wired
Example 2 - Enabling Both IP Protocols
The following command determines that both IPv4 and IPv6 protocols
are enabled.
config:#
network ip proto both
Example 3 - Wireless Authentication Method
The following command sets the wireless authentication method to PSK.
config:#
network wireless authMethod PSK
Example 4 - Static IPv4 Configuration
The following command enables the Static IP configuration mode.
config:#
network ipv4 ipConfigurationMode static
Time Configuration Commands
A time configuration command begins with time .