Raritan PMC-1000 - Operating the Dot-Matrix LCD Display

Chapter 1: Installation and Initial Configuration
36
Operating the Dot-Matrix LCD Display
Enter manual mode when you want to operate the dot-matrix LCD
display. You can use the dot-matrix LCD display to:
• Show information of the BCM2 device, built-in components, or
connected peripheral devices
• Control outlets if your model supports outlet-switching
• Control actuators if any
Color changes of the display's top and bottom bars:
• In the manual mode, both the top and bottom bars will turn yellow or
red to indicate the presence of any alert. For color definitions, see
Yellow- or Red-Highlighted Sensors (see " The Yellow- or
Red-Highlighted Sensors " on page 90, on page 121).
Screen with yellow bars
Screen with red bars
All alerts enter the warning level only. Partial or all alerts enter the critical
level.