Raritan PMC-1000 - Appendix E Additional BCM2 Information; RJ45-To-DB9 Cable Requirements for Modem Connections (for Ix7 Only)

571
In This Chapter
RJ45-to-DB9 Cable Requirements for Modem Connections (for iX7™ Only)
................................................................................................................. 571
Reserving IP Addresses in DHCP Servers .............................................. 572
Sensor Threshold Settings ...................................................................... 576
Altitude Correction Factors ..................................................................... 584
Ways to Probe Existing User Profiles ..................................................... 585
Raritan Training Website ......................................................................... 585
Role of a DNS Server ............................................................................... 585
Installing the USB-to-Serial Driver (Optional) ........................................ 586
Initial Network Configuration via CLI ...................................................... 587
Device-Specific Settings .......................................................................... 592
TLS Certificate Chain ............................................................................... 592
RJ45-to-DB9 Cable Requirements for Modem Connections (for iX7™ Only)
An RJ45-to-DB9 adapter/cable is required for connecting a modem to an
iX7
™
PDU.
A third party RJ45-to-DB9 adapter/cable needs to meet the following
requirements.
• RJ-45 to "DB9 male"
• RX/TX and according control pins are NOT crossed
• With the following pin assignments:
Pin signal
DB9 pin No.
RJ-45 pin No.
DCD 1 5
RxD 2 6
TxD 3 3
DTR 4 2
GND 5 4
DSR 6 7
RTS 7 1
CTS 8 8
RIR 9 N/A
Appendix E
Additional BCM2 Information