Raritan PMC-1000 - Chapter 3 Using the Web Interface

Chapter 2: Connecting External Equipment (Optional)
69
3. Connect the asset strip assembly to the BCM2 device, using a
network patch cable (CAT5e or higher).
 Connect one end of the cable to the RJ-45 connector on the
MASTER asset strip.
 Connect the other end of the cable to the FEATURE port on the
BCM2 device.
The BCM2 device supplies power to the connected asset strip
assembly. All LEDs on the asset strip assembly may cycle through
different colors during the power-on process if the asset strip's
firmware is being upgraded by the BCM2. After the power-on or
firmware upgrade process completes, the LEDs show solid colors.
Note that the LED color of the tag ports with asset tags connected
will be different from the LED color of the tag ports without asset
tags connected.
(A) MASTER asset strip
(B) Asset tags
(C) IT devices
(D) BCM2