Chapter 2: Connecting External Equipment (Optional)
Mylar section with the adhesive tape
Tag ports
Cable socket(s) for connecting the tag
connector cable
Note: Each tag port on the blade extension strip is labeled a number,
which is displayed as the slot number in the BCM2 device's web
interface.
To install a blade extension strip:
1. Connect the tag connector cable to the blade extension strip.
Plug the cable's connector into the socket at either end of the
blade extension strip.
2. Move the blade extension strip toward the bottom of the blade
chassis until its mylar section is fully under the chassis, and verify
that the blade extension strip does not fall off easily. If necessary,
you may use the adhesive tape in the back of the mylar section to
help fix the strip in place.
3. Connect one end of an asset tag to a blade server and the other end
to the blade extension strip.
To Next Page
Loading...
