RAS MULTIBEND 9000 - 6. Working With the Machine; 6.1 Occupational Safety Directives

6. WORKING
WITH
THE MACHINE
6.1. OCCUPATIONAL
SAFETY
DIRECTIVES
WORKING
WITH
THE MACHINE
The machine
may only be
put
into
operation
if the operator
has
been trained, is authorized,
and has read and understood
this operating manual,
particularly
Ghapter 2
"SAFETY", as
well as the separate'CNC-COLOURGRAPHIC-CONTROLLER
MULTIBEND 9000
for
RAS 74.2G40"
operating
instructions,
supplied
with the machine, and the
"Siemens safety informa-
tion".
All safety devices
must
be
fitted before the machine
is
switched on.
The information
plates,
fitted
to
the machine, must have been
read
and understood before switching on.
The machine must be disconnected
from the electric system
before changing
the rails. To do this,
turn
off
the main switch
on the switchgearcabinet
and secure with a
padlock.
Always
read Section 6.2.9
"REPLACING THE RAILS" in
this
operating
manual
beforehand.
The machine must
always be at a standstill and disconnected
from the electric
system before any adjustment
or main-
tenance
work is canied
out. Adjustment and maintenance
work
may
only
be carried out by
authorized
personnel.
RAS 74.2A-4A
MULTIBEND
9OOO
September
7, 1993
6-1